Jibboom

A jibboom (also spelt jib-boom) is a spar used to extend the length of a bowsprit on sailing ships.[1] It can itself be extended further by a flying jib-boom.[1] The heel (i.e. rear and lower) end of the flying jib-boom is attached to the jib-boom, and the heel of the jib-boom to the bowsprit. The point (i.e. higher and fore end) of the flying jib-boom is generally the fore-most extent of a ship. The jib- and flying jib- booms carry the tacks of the jib and flying jib sails, respectively, and the stay for the fore topgallant mast and the royal stay.

A diagram of the three spars and some of the rigging that can make up a bow: A.) Bowsprit, B.) Jibboom, C.) Flying jib-boom, D.) Jibstay. E.) Fore Topgallant Stay, F.) Flying Jibstay, G.) Fore Royal Stay, H.) Topmast stays, I.) Outer Forestay, J.) Inner Forestay

Jib-boom

The jib-boom is—as the name suggests—the boom for the jib, extending its foot.[1] On smaller, merchant, sailing ships, it is commonly attached to the bowsprit by a cap and a saddle, either lashed down or secured with a crupper chain.[1][2][3] Alternatively, it can be attached by a boom iron and a cap, or even by two boom irons.[3] The cap and saddle allow it to be withdrawn aft along the bowsprit as a ship enters harbour, reducing the opportunity for passing ships to glance against it and snap it off from the bowsprit.[3]

It is octagonal in cross-section at its heel end.[4] If secured by a chain to the bowsprit, it is iron-scored at the heel.[4] At its point it is also (partly) octagonal in cross-section, the same as is the boom iron that secures the flying jib-boom to it.[4] The flying jib-boom lies against the upper starboard side of the octagon.[4]

The stay of the fore topgallant mast is attached to the jib-boom at the extremity of its point.[1][4][5] The stay for the jib sail is attached to the shouldering at its heel.[4] Just as the bowsprit has bobstays, in order to counteract the upward force from the jib and fore topgallant stays a martingale hangs down from the point of the jib-boom to a dolphin striker, pulling downwards on the jib-boom.[6]

Flying jib-boom

The flying jib-boom is secured, at its heel end, to the jib-boom by a boom iron and lashing.[1] At its point, it has a sheave for the royal stay.[4][5] Another sheave at the heel is for a heel rope.[4] It is to the point that the tack of the flying jib sail is drawn out.[3]

References

Cross-reference

1. Smyth 2008, p. 412.
2. Nares 1868, p. 45.
3. Jamieson 1829, p. 530.
4. Boyd 1864, p. 133.
5. Moore 1801.
6. Biddlecombe 1925, p. 20.

Sources used

• Biddlecombe, George (1925). "Martingale". The Art of Rigging. Dover Maritime Series (reprinted 1990 by Courier Dover Publications ed.). Salem, Massachusetts: The Marine Research Society. ISBN 978-0-486-26343-4.CS1 maint: ref=harv (link)
• Boyd, John McNeill (1864). A manual for naval cadets (3rd ed.). London: Longman, Roberts, & Green.CS1 maint: ref=harv (link)
• Jamieson, Alexander (1829). "Jib-Boom". A dictionary of mechanical science, arts, manufactures, and miscellaneous knowledge. 1. London: H. Fisher, Son & Co.CS1 maint: ref=harv (link)
• Moore, J. J. (1801). "Stay". The British mariner's vocabulary: or universal dictionary of technical terms and sea phrases used in the construction, equipment, management and military operations of a ship. London: Hurst.CS1 maint: ref=harv (link)
• Nares, George Strong (1868). Seamanship (4th ed.). Portsmouth: James Griffin and Co.CS1 maint: ref=harv (link)
• Smyth, William Henry (2008). "JIB-BOOM". In Belcher, Edward (ed.). The Sailor's Word: A Complete Dictionary of Nautical Terms from the Napoleonic and Victorian Navies. Fireship Press. ISBN 978-1-934757-41-3.CS1 maint: ref=harv (link)

Further reading

• Lees, James (1979). "Rigging to the flying jibboom". The masting and rigging of English ships of war, 1625–1860. Naval Institute Press. pp. 52 et seq. ISBN 978-0-87021-847-7.CS1 maint: ref=harv (link)