Aerial saw

An aerial saw is a saw which is flown through the air. The aerial saw may also be known as a helicopter aerial saw.

A ten-blade saw demonstrated by FirstEnergy in 2017

Large aerial saws are flown by helicopter to trim trees in remote locations when they overgrow power lines, pipelines or other infrastructure. A design used in the Appalachian region has ten circular saws on a twenty-foot shaft which is carried by an MD 500 helicopter, typically using a rigid boom of about 80 feet long on a gimbal mount, so that the saw can swing below the aircraft. The saw blades are powered by a 28-horsepower engine and the assembly weighs 830 pounds. This design is used to prune trees for customers such as American Electric Power. Another design, with a single, horizontal, 47-inch, circular saw blade, is used to cut the tops off trees which are at risk of falling across power lines.[1][2][3]

Operation

The aerial saw is not used only to make new paths for transmission or power lines, but also for maintaining the paths initially cut by the aerial saws. The aerial saw is suspended from a helicopter able to support the swinging weight of the saw. Once the saw is attached to the helicopter, it is turned on and precisely piloted alongside potentially troublesome tree branches. Normally, more than one pass by the branches is needed to ensure adequate coverage.[4] The branches are then picked up by a ground crew and disposed of properly.

Design

The design of the aerial saw is fairly simple. It involves ten two-foot diameter circular saw blades (normally seen in Table saws) mounted on a vertical shaft which is around twenty feet long. Those ten circular saw blades are driven by a 28 horsepower engine. The engine is able to run all ten blades at speeds up to four-thousand revolutions per minute (RPM). The shaft is then attached to a ninety-foot aluminum boom (or beam) then attached to the helicopter where the pilot can remotely control the saw.[4]

Safety & Regulations

The aerial saw is inherently dangerous due to its construction and size. This danger allows for the quick removal of tree branches that are a potential hazard. This danger is kept in line with very strict protocols and precautions. In order for one of these saws to be used in a residential area, a safety buffer must be in place prior to work. The operation must be monitored and certified by the Federal Aviation Administration (FAA) for each business to use. This certification, as well as the required insurance coverage, is earned only through safe operation of the power saw.[5]

History

Prior to 1986, the side trimming of trees for electric utilities was done by climbing crews or workers armed with mechanical trimmers. Then in 1985, Aerial Solutions Inc. (ASI) pioneered the use of helicopters for side trimming of paths for more than 20 utility, pipeline companies, and governmental agencies throughout the United States.[6] American Electric Power (AEP) began using the aerial saw to clear out paths for transmission lines in 1986. These transmission lines were first established in Virginia, West Virginia, Kentucky and Tennessee, where the terrain is known to be very mountainous and difficult to access with hand power tools.

References
  1. Rick Mowbray; William Cox IV (16 May 2017), "Aerial Saw Is Boon to Line Trimming", T&D World
  2. Guy Maher (11 May 2015), "A Cut Above", Vertical
  3. Jennifer Leman (19 September 2019), "We Can't Stop Watching This Helicopter Chainsaw Slice Up Tree Limbs", Popular Mechanics
  4. "StackPath". www.tdworld.com. Retrieved 2020-06-10.
  5. Solon, Ohio. "Aerial Tree Trimming/Aerial Saw Fact Sheet". Retrieved 2020-06-10.
  6. "Aerial Solutions, Inc : Pioneering helicopter based tree trimming". www.aerialsolutionsinc.com. Retrieved 2020-06-10.


This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.